Features

• Complied with ATX 12V and EPS12V standard
• Active Power Factor Correction (PFC) meet EN61000-3-2
• High efficiency and reliability
• Compatible with European Union Directive 2002/95/EC 
  (Restriction on Hazardous Substances).
• Remote ON/OFF function
• Internal 12V DC fan included
• Noise Killer (thermal fan speed control function)
• Low noise and ripple
• Output over voltage, short circuit, and over current protection
• 100% Hi-pot, ATE, and burn-in tested
• Re-settable power shut down
• Complies with FCC part 15 subpart J class B 115Vac operation, 
  and CISPR 22 class B at 230Vac operation
• Approved by UL/CUL6095-1, TUV EN60950-1, CB,EMC,FCC
  Input Characteristics

Input Range: 90 ~ 264Vac, Full Range Input
Frequency: 47 ~ 63Hz
Input Current: Max 6A @ 115Vac, 3A@ 230Vac
Inrush Current: No damage.

Output Characteristics

Specification

• Temperature Range: Operating: 0°C ~ +50°C on full load;
   storage & shipping: -20°C ~ +80°C
• Humidity: 5-90% on operating, 5-95% on storage
• Dielectric Withstand: Primary frame ground 1800V AC for
  1 second
• Efficiency: typical up to 84%
• Rise time: Less than 20ms
• Hold-up Time: 17ms minimum at nominal input voltage
• Power Good Signal: Power on delay time 100 ~ 500ms, off
  delay 1ms minimum (TTL and CMOS compatible)
• Leakage Current: Less than 3.5mA at 264Vac, 50Hz
• MTBF: 100,000 hours on maximum load at +25°C
• Dimensions (LxWxH): 190x100x40.5mm /7.5x3.9x1.6inch 
  Output Voltage Minimum Load Normal Load Maximum Load Load Reg. Ripple &                            Noise  

+3.3V 0.5A 8A 16A ± 5% 50mV P-P
+5V 0.5A 9A 18A ± 5% 50mV P-P
+12V1 1.0A 8A 16A ± 5% 120mV P-P
+12V2 1.0A 8A 16A ± 5% 120mV P-P
-12V 0.0A 0.4A 0.8A ± 10% 120mV P-P
-5V 0.0A 0.15A 0.3A ± 10% 100mV P-P
+5Vsb 0.0A 1.25A 2.5A ± 5% 50mV P-P

*+3.3V and +5V total output not exceed 130W