Description
Features
- Complied with ATX12V standard
- Active power factor correction (PFC) meet EN61000-3-2
- Hot Swap Module
- High efficiency and reliability
- Remote ON/OFF function
Internal 12V DC fan included
- Internal 12V DC Fan included
Low noise and ripple
- Output over voltage, short circuit, and over current protection
- 100% Hi-pot, ATE, and burn-in tested
- Re-settable power shut down
- Complies with FCC part 15 subpart J class B 115Vac operation, and CISPR 22 class B at 230Vac operation
- Approved by : UL/CUL60950-1 2nd TUV EN60950-1 2nd, CB report, FCC, EMC
Input Characteristics
- Input Range: 90 ~ 264Vac(RMS), Full Range Input
- Frequency: 47 ~ 63Hz
- Input Current: Max 6.0A(RMS) @ 100-240Vac
- Inrush Current: 80A Max@100~240Vac Cold start
Specification
- Temperature Range:Operating: 0 C ~ +50 C on full load
- Humidity: 5-85% on operating,5-95% on storage
- Dielectric Withstand: Primary frame ground 1800V AC for3 second
- Efficiency: Min 65% @ 100% Load & 72% @ 50% load
- Rise Time: Less than 70mS
- Hold-Up Time : 17mS minimum at nominal input voltage
- Power Good Signal : Power on delay time 5 ~ 400ms, off delay 1ms minimum (TTL and CMOS compatible)
- Leakage Current: Less than 3.5mA at 264Vac, 50Hz
- MTBF: 100,000 hours on maximum load at +25 C
- Dimensions (LxWxH):300mm*101mm*84.4mm /11.8 x 4×3.3 inch
Output Characteristics
| Output Voltage | Min Load | Normal Load | Max Load | Load Reg. | Ripple & Noise |
| +3.3V | 0.5A | 10A | 20A | 5% | 50mV P-P |
| +5V | 0.5A | 12.5A | 25A | 5% | 50mV P-P |
| +12V1 | 0.5A | 7.5A | 15A | 5% | 120mV P-P |
| +12V2 | 0.5A | 7.5A | 15A | 5% | 120mV P-P |
| +12V3 | 1.0A | 7.5A | 15A | 5% | 120mV P-P |
| -12V | 0.0A | 0.25A | 0.5A | 10% | 120mV P-P |
| -5V | 0.0A | 0.1A | 0.2A | 10% | 120mV P-P |
| +5Vsb | 0.0A | 1.0A | 2.0A | 5% | 50mV P-P |
* +3.3V and +5V total output not exceed 150W
* Maximum combined current for the 12V outputs shall be 24A.
* Total output for this subject power supply is 350W.
